Skip to content Opens in a new tab

Caravan Towing Guide

The weights, the rules and the setup for towing a caravan in Australia.

Updated 20 October 2026

Every figure on these pages is a rough estimate from the maker's published specs. They don't allow for GVM upgrades, aftermarket towbars or accessories. Check your vehicle's compliance plate and owner's manual, and weigh your rig before you tow. Titanium is not affiliated with or endorsed by the vehicle makers named.

Caravan weights explained

Every caravan has a plate showing its tare, ATM and GTM, and every tow vehicle has a GVM, a GCM and a towing capacity. These are the figures that decide whether a rig is legal and safe to tow.

Tare
The weight of the empty van with its standard equipment and factory options, before water or gear go in. Anything added after it leaves the factory, like a TV, an extra gas bottle or an awning, counts as load.
ATM (Aggregate Trailer Mass)
The most the van can weigh fully loaded, including the weight it puts on the towball. It's a rating set by the maker and shown on the plate.
GTM (Gross Trailer Mass)
The most the van's axles can carry when it's hitched up and fully loaded. It's also a rating on the plate.
Payload
ATM minus tare, which is how much you can load into the van.
Ball weight
The weight the van puts on the towball, also called towball download. It counts toward the tow vehicle's GVM.
Kerb weight
The tow vehicle with a full tank of fuel, its fluids and standard equipment, and nobody in it.
GVM (Gross Vehicle Mass)
The most the tow vehicle can weigh loaded, including people, gear, accessories and the ball weight.
GCM (Gross Combination Mass)
The most the loaded tow vehicle and the loaded van can weigh together, as set by the vehicle's maker.
Braked towing capacity
The heaviest trailer the vehicle can tow when the trailer has its own brakes. Unbraked towing capacity is the same for a trailer without brakes, and it's never more than 750kg.

ATM vs GTM

ATM is the whole van at its loaded limit, measured with nothing hitched. GTM is the part of that weight the van's own axles carry once it's hitched. The difference between the two is the ball weight: when a van is at its maximum load and loaded evenly, ATM minus GTM is what sits on the towball.

Both are ratings the maker sets, so you can't read them off a weighbridge. What you can weigh is how close your loaded van is to them. GTM matters for more than the axles, because it's the figure that decides what brakes a van needs.

GVM vs GCM

GVM is the tow vehicle on its own, loaded with everything it carries plus the ball weight. GCM is the tow vehicle and the van together. Both are set by the vehicle's maker and it's illegal to exceed either one.

A GCM is often less than the GVM plus the towing capacity. That means a vehicle loaded to its GVM may not be able to tow a van at its full towing capacity, because together they'd go over the GCM.

Working out what you can tow

The loaded van can't weigh more than the lowest of these: the vehicle's towing capacity, the towbar's rating, the coupling's rating, the van's ATM and the tyres' load rating. A towbar rated higher than the vehicle doesn't raise what the vehicle can tow, and a towbar rated lower than the vehicle lowers it.

Then check four things with everything loaded:

  1. The loaded van is within the vehicle's braked towing capacity.
  2. The ball weight is within the vehicle's and the towbar's towball limit.
  3. The loaded vehicle plus the ball weight is within its GVM.
  4. The loaded vehicle plus the loaded van is within its GCM.

We recommend a van whose ATM is within your vehicle's towing capacity. Queensland notes a van may not be covered by comprehensive insurance if its on-road weight exceeds the vehicle's towing capacity.

Ball weight and loading

There's no single official figure for ball weight. Transport for NSW says about 5 to 10 percent of the loaded van, the WA Department of Transport says 8 to 10 percent of ATM, and RACQ says not to go over 10 percent of ATM. Every one of them puts the vehicle's and the towbar's own towball limit first. Too little ball weight can make a van unstable, and too much loads up the vehicle's rear and affects its steering and braking.

  • Pack the heaviest items low and over the van's axles, and keep lighter things up high. NSW suggests about 60 percent of the load forward of the axle centre.
  • Get the rig sitting level by loading it properly first. A weight distribution hitch isn't a fix for a badly loaded van.
  • Water adds 1kg a litre, and a full 9kg gas cylinder adds about 18kg. Water in the tanks also changes the ball weight.
  • Fill the water tanks when you arrive if you can, and allow for grey water, the cassette toilet and what you pick up along the way.
  • Keep the load in the tow vehicle's boot down. It counts toward the vehicle's GVM and the GCM.
  • Some vehicles, especially European ones, have low towball limits for their towing capacity. Check your owner's manual and the towbar's plate.

Weighing your rig

The plate tells you the van's ratings, not what it weighs once you've packed it, so weigh the loaded rig and weigh it again after you add anything. The National Measurement Institute keeps a map of public weighbridges, and mobile weighing services come to you. Queensland's Department of Transport and Main Roads sets out this order at a weighbridge:

  1. Drive on and stop before the van's wheels reach the bridge. That's the loaded tow vehicle, which must be within its GVM.
  2. Drive the whole rig on. That's the combination, which must be within the GCM.
  3. Drive forward until the vehicle's rear wheels are off and the van's wheels are still on. That's the van's axle load, which must be within its GTM.
  4. Lower the jockey wheel onto the bridge and unhitch. That's the whole van, which must be within its ATM.
  5. Weigh the ball weight with a stand under the coupling and the van's axles off the bridge, or with a towball scale.

Brakes, chains and couplings

Brake requirements depend on the van's GTM, not its ATM:

  • Up to 750kg GTM, brakes aren't required.
  • Over 750kg GTM, the van needs brakes worked by a signal from the tow vehicle. Override brakes are allowed up to 2,000kg GTM.
  • Over 2,000kg GTM, the brakes must work on every wheel and the van needs breakaway brakes that apply on their own and stay on for at least 15 minutes if the van comes off the vehicle. In NSW the brakes must also be operable from the driver's seat.

Safety chains depend on the van's ATM:

  • Up to 2,500kg ATM, at least one chain.
  • Over 2,500kg and up to 3,500kg ATM, two chains.
  • Over 3,500kg ATM, two chains of 6mm Grade T steel, each with a breaking load above the van's ATM.

Keep the chains as short as practical and cross them under the coupling, so the drawbar can't hit the ground if the coupling lets go. Don't use padlocks.

A standard 50mm towball is rated to 3,500kg at most. A van plated above 3,500kg ATM needs a coupling and towbar rated to its ATM, and a towbar over 3.5 tonnes must be marked with its maker, the vehicle it suits and its rating.

Setting up the tow vehicle

  • Brake controller. Set it up to the maker's instructions, then adjust the gain until the van brakes at the same rate as the vehicle. If the van pulls back on the vehicle under braking, lower the gain. If it pushes, raise it.
  • Weight distribution hitch. It moves some of the ball weight onto the vehicle's front axle to keep its ride height and steering. Don't use one where the vehicle, van, towbar or hitch maker advises against it, and check with the towbar maker first, since it can overload the towbar.
  • Mirrors. In WA you must fit towing mirrors when the van is wider than the vehicle, and NSW says you must have extended mirrors if you can't see down the length of the van from the driver's seat. A reversing camera doesn't replace them.
  • Trailer sway control. Transport for NSW recommends a tow vehicle fitted with electronic trailer sway control.
  • Tyre pressures. Use the vehicle's placard or handbook, which may give higher rear pressures for towing, and the van maker's figures for the van.

Licences

A car licence covers a vehicle with a GVM up to 4.5 tonnes. In NSW, Victoria and the ACT it lets you tow a single trailer of up to 9 tonnes GVM, within the vehicle maker's limits. A tow vehicle plated over 4.5 tonnes GVM, which includes some of the heavier American pickups, needs a light rigid licence. It's the vehicle's own plated GVM that decides it.

Learner and provisional drivers' towing rules differ between states. In NSW, learner and provisional drivers can't tow a caravan, and Victoria doesn't let learners or most P1 drivers tow. South Australia doesn't restrict them. Check your own state's rules.

Speed limits and road rules

  • WA. Any vehicle towing a trailer or caravan is limited to 100km/h.
  • NSW. A vehicle over 4.5 tonnes GVM, or a vehicle and trailer with a GCM over 4.5 tonnes, is limited to 100km/h whatever the posted limit. That GCM test likely covers most four-wheel drives towing a full-size caravan.
  • Following distance. A vehicle and caravan 7.5 metres or longer counts as a long vehicle. Outside built-up areas, on a road with one lane each way, keep at least 60 metres behind another long vehicle.
  • Letting traffic pass. Keep left, watch for traffic building up behind you and pull over where it's safe to let it pass. Don't speed up while someone is overtaking you.
  • Road trains. In the NT, slow down and pull onto the shoulder when a road train is coming the other way on a single lane highway. When one is overtaking you, keep your speed and stay left, and don't travel in convoy.

Rules change and differ between states, so check with the transport authority for each state you're travelling through.

On the road

  • Sway. Wind, passing trucks, soft road edges, uneven loading and too much weight can all start a van swaying. Don't brake hard with the vehicle's brakes. Apply the van's brakes on their own, gently, with the brake controller's manual control, and hold a steady speed until it settles. Learn where the manual control is so you can find it without looking.
  • Trucks and buses. Slow down a little when a large vehicle passes you in either direction, since the wind it pushes can start the van moving.
  • Stopping. Leave a longer gap to the vehicle in front, and more again in the wet. The heavier and longer the van, the more room you'll need.
  • Hills. Use a lower gear going downhill so the brakes don't overheat.
  • Corners. The van cuts in on corners, so take turns a little wider.
  • Crosswinds. Slow down in strong gusts, and in very high winds don't tow at all.
  • Rough roads. Slow down on bumpy or unsealed roads and over rail crossings.
  • Fuel. Fuel use goes up when towing, especially above 90km/h.
  • Rest. Towing is more tiring than normal driving, so plan more rest stops and shorter days. At each stop, check the coupling, doors, hatches, load and tyres, and feel for hot wheel bearings.

Before you go

Transport for NSW's caravan checklist covers the hitch-up:

  • The coupling and ball are the same size, and the coupling is locked on.
  • The safety chains are connected as the maker specifies and crossed under the towball.
  • The breakaway cable is connected and its battery is charged, on any van over 2,000kg GTM.
  • The van's lights and number plate are visible, connected and working.
  • The jockey wheel is removed and stored, or locked in its travel position.
  • The corner steadies are up.
  • Roof hatches, windows, doors and stone shields are shut and secure.
  • The awning is stowed and locked.
  • The gas is off and the fridge door is shut.
  • The 240V lead is unplugged and stored, and the TV antenna is down.
  • Everything inside the van is secured.
  • The van's handbrake is off.
  • Tyre pressures and wheel nuts are set to the maker's figures, and the spare is packed.
  • The brakes work on every axle, and the wheel bearings are adjusted and greased.

Reversing a caravan

Put your hand at the bottom of the steering wheel. The back of the van goes the way your hand goes, so move your hand left and the van goes left. Use small movements and go slowly, since speed turns small errors into big ones. If the van starts to disappear from one mirror, steer gently toward that side to bring it back. If it gets away from you, stop, straighten up and start again.

Have someone watch the back of the van from where you can see them, never directly behind it, and agree on simple hand signals or use UHF radios. Practise in an empty car park before you need to do it at a campsite.

Frequently asked questions

What is ATM on a caravan?

ATM, or Aggregate Trailer Mass, is the most the caravan can weigh fully loaded, including the weight it puts on the towball. The maker sets it and it's on the van's plate.

What is GCM?

GCM, or Gross Combination Mass, is the most the loaded tow vehicle and the loaded caravan can weigh together. The vehicle's maker sets it, and it's often less than the vehicle's GVM plus its towing capacity.

What's the difference between ATM and GTM?

ATM is the whole van at its loaded limit with nothing hitched. GTM is what the van's own axles carry once it's hitched. The difference between them is the ball weight, and the van's GTM decides what brakes it needs.

What's the difference between GVM and GCM?

GVM is the most the tow vehicle can weigh on its own, including the ball weight. GCM is the most the vehicle and van can weigh together.

How much ball weight should a caravan have?

There's no single official figure. Transport for NSW says about 5 to 10 percent of the loaded van, the WA Department of Transport says 8 to 10 percent of ATM and RACQ says not to go over 10 percent of ATM. The vehicle's and the towbar's own towball limits come first.

Do I need electric brakes on my caravan?

The rules don't name electric brakes. Over 750kg GTM a van needs brakes worked by a signal from the tow vehicle, and override brakes are allowed up to 2,000kg GTM. Over 2,000kg GTM it needs brakes on every wheel and breakaway brakes. Electric brakes are the usual way caravans meet those rules.

Can I tow a caravan with an ATM above my towing capacity?

We recommend a van whose ATM is within your vehicle's towing capacity.

Speak to our team

Tell us what you are after and our team will help you choose.